Johnson Automation & Control -»   Products

Water Level Controller

DOMESTIC APPLICATION MODELS

Programmable Timer Controller
This model is best suitable for those areas where the water supply from the municipal corporation reaches at different time zones. With the help of user friendly programmable timer you can set the start & stop time of your pump set.

Example: The start time is set at 5:00am and stop time at 5:03am. The motor will automatically start at 5:00am, if water reaches before 5:03am then motor will continue to run until water stops coming or the Overhead Tank gets filled up.

Now suppose water doesn't reach before 5:03am, then motor will stop automatically. Now again the motor will start at its second programmed time, i.e., 5:10am & so on. It is the hit & trial method and is running successfully with great convenience. This also safeguard your pump-set against any longer dry running. There are two models of programmable timer. You can program 8 sets of time in timer (A) while 24 times in timer (B) in a day.

Programmable & Cyclic Timer Controller
With Programmable Timer Controller you can start & stop the motor up to 24 times in a day only, but with this model you can run your motor for checking water availability after every ten minutes & as the water reaches, it will continue to run until the tank gets filled up.

Example: In programmable timer, if we set the start time at 5:00am & stop time at 7:00am & consecutively set the time delay of 10 minutes in cyclic timer, then motor will automatically starts after every 10 minutes for checking availability of water.



Submersible Pump Controller
There are various models of HYDROtECH Submersible Pump Controller suiting various types of Starter Panels used. Generally the starter used for submersible pumps are Direct-On-Line (DOL), Capacitor Start Capacitor Run (CSCR) & Star – Delta Starter.

HYDROtECH is available for all the three types of starters. It is very easy to interface  HYDROtECH with any type of starter. We are distinctly ahead of our competitors in interfacing the controller with any type of starter.



Sump / Sewer Pump Controller
As the level of liquid reaches the top level of the sump / sewer, motor will start automatically and as the liquid reaches bottom level, motor will switch off immediately.

Type of water level sensor used is to be considered while installation. For liquids, Stainless Steel probe duly plastic moulded sensors will be used while for viscous or sewage water Radio Frequency PTFE Type level probes will be installed.